pentaxian450

Joined: 10th February 2008

All Forum Comments

Topics Created Topics Contributed Forum Comments Photo Comments

All Forum Comments

pentaxian450
Tord wrote:
with the IS on, and sometimes the SR as well on
Using both together is as good as not using any. They will both counteract the same shake, so a "shake" in the opposite direction will result because it will double the shake reduction needed for a sharp picture.

Comment by pentaxian450 posted on SR or IS at 10/07/2011 - 11:30

pentaxian450
You're more likely to see banding at high ISO and continuous tones like a sky than low ISO with varying tones. All digital cameras, without any exceptions, will show banding under some extreme conditions. Unlike films, digital cams can't record continuous tones. It records by "steps". If the subject is smoothly and slowly fading, the steps will sometimes show as banding.

Comment by pentaxian450 posted on K5 High ISO banding? at 27/06/2011 - 03:01

pentaxian450
I think if you needed that much power, you had the wrong lighting set up for the subject you wanted to photograph. Generally, the umbrella is close enough to the subject that you don't need such power, unless you're trying to photograph an Airbus A-380 in a studio. And then, one flash and one umbrella would be unsuitable...Maybe if we knew what you were trying to photograph, we could come up with an alternative solution...

Comment by pentaxian450 posted on Not enough power at 27/06/2011 - 02:54

pentaxian450
Hey, Don.

I just bought a BMW R1200 RT to commute to work. It's a wonderful bike. Not as fast as the "R" bikes, but a very nice bike to drive. And it 'drinks' a lot less than my van.

Comment by pentaxian450 posted on Ok 'Canada Don' I found my perfect motorcycle at 25/06/2011 - 13:29

pentaxian450
When you have many pictures to be taken with an exposure that is different than the one suggested by the camera's light meter, exposure compensation is the way to go. But, for one picture only, using the AEL button is much faster. You move the camera a little until you get the lightmeter reading you want, press the AEL button, recompose and take the picture.

Comment by pentaxian450 posted on AEL at 25/06/2011 - 13:24

pentaxian450
Being in Canada, the contracts and rates are different, but mine costs me about $15.00/month.

Comment by pentaxian450 posted on How Much Does Your Mobile Phone Cost. at 14/06/2011 - 23:34

pentaxian450
Something's not "kosher". Your title says tomorrow, but your post says July 15th, so which one is it?:::

Comment by pentaxian450 posted on Tomorrow's Eclipse at 14/06/2011 - 23:29

pentaxian450
The problem depicted is not a "parallax" problem. It's caused by the eye being too far from the viewfinder to be able to see all the edges at the same time. Large glasses are worst for this problem, because they generally tend to sit further down your nose than small glasses.

Parallax error happens only when the viewfinder is a separate entity (like beside and above the lens), as opposed to SLR/DSLR where you see the image through the lens that is on the camera.

Comment by pentaxian450 posted on Parallax error (I wear glasses) at 07/06/2011 - 00:10

pentaxian450
I remember photographing a wedding (a long time ago) with films, and the pro lab I was using got a processor malfunction, and ruined all the films. So, as you can see, nothing has been re-invented.

Anyway, your best bet is a card recovery software. Good luck.

Comment by pentaxian450 posted on Potential disaster, please help :-( at 06/06/2011 - 01:51

pentaxian450
timd wrote:
The_archaeologist wrote:
... Now turn it (or the camera) through 180 degrees and note the position of the bubble again....
This, of course, assumes that that the surface you have placed the camera is perfectly level...

(they do call me PerdanTim)
If you don't move the camera at all and turn the level 180 deg., then the reading should be the same, level or not. If the camera is not level, the bubble will be off, and it will be off by the same amount if you turn the level around 180 deg.

You'll find a discrepancy if the level is not accurate.

Comment by pentaxian450 posted on Levels at 03/06/2011 - 17:17

Proudly supporting Pentax User

Samsung Logo Asahi Pentax Logo