All Forum Comments
Comment by HarisF1 posted on My 60-250 Journey. at 26/12/2022 - 12:30
And if you don't like it, you can simply sell it on as it will not be losing value any time soon.
Comment by HarisF1 posted on Pentax A*200 Macro at SRS at 11/11/2022 - 17:36
I've got a few unused gems which I would rather move on, but I'd ultimately be giving them away so they are better off left in storage.
Comment by HarisF1 posted on Why does everyone rate MPB? at 05/11/2022 - 11:59
Comment by HarisF1 posted on Lens not functioning in manual mode at 31/10/2022 - 08:27
Comment by HarisF1 posted on Lens not functioning in manual mode at 29/10/2022 - 11:31
These shots are all superb, a couple magazine worthy ones too - but they all look like they were shot with a special lens.
Comment by HarisF1 posted on Time to replace this lens? at 25/10/2022 - 08:23
Comment by HarisF1 posted on New (to me) F series 24 - 50mm lens. First outing. at 02/10/2022 - 08:52
I guess this is Pentax finally getting with the times and producing trendy looking stuff.
Comment by HarisF1 posted on Pentax K-3 Mark III Jet Black Limited Edition Body at 18/09/2022 - 22:27
2 has pleasing colours and gives a good sense of speed.
5 provides the eye with a bit of relief and an area of focus.
It looks like a difficult scene to capture, with awkward leading lines. The two pictures I've picked both demonstrate a bit of intent IMO.
Comment by HarisF1 posted on Fisheye Train Spotting at 17/09/2022 - 22:26
"He's bought a new lens, I guess he'll want me to pose for the fans..."
Comment by HarisF1 posted on I think it works ok ! at 14/09/2022 - 18:56


The issue sounds really intriguing, maybe something wrong with the circuitry or EEPROM.
I'd look to buy a cheap one with a dead SDM in order to swap the PCB. You could end up with one fully working lens.
And regarding compatibility with the K-1, if you remove the baffle you get a sizeable reduction in vignetting. It's not a difficult process (remove three screws on the mount, pull the flocked cylinder off from the rest of the baffle (it's glued on), then reinstall.
I wouldn't go for the dremel option for marginal gains as it's a permanent change.