All Forum Comments
Comment by HarisF1 posted on Wanted Pentax mount 500mm lens at 30/12/2020 - 00:41
Comment by HarisF1 posted on AP Mag - Voting for their 2021Retailer & Camera Awards :( at 27/12/2020 - 23:52
Comment by HarisF1 posted on Progress report on PENTAX's new APS-C-format digital SLR flagship camera: officially named PENTAX K-3 Mark III at 26/12/2020 - 17:32
I've seen it :O
It's a competitive price compared to the options from Japan.
Comment by HarisF1 posted on LTD: Pentax A*200mm Macro on Ebay UK at 23/12/2020 - 15:13
It's a competitive price compared to the options from Japan.
Comment by HarisF1 posted on LTD: Pentax A*200mm Macro on Ebay UK at 22/12/2020 - 10:10
Put your camera in Manual mode and use the same settings for a shot taken in both LV and viewfinder modes. If there's no difference then again it points to the aperture block.
Another test is to look into the front of the lens as you take an image that is wide open. The lens blades should open up when the shutter snaps. Try this for the lowest f stop, then slowly move to high f values. If there's no change then it's the fault mentioned above.
If the camera passes these tests then the fault lies elsewhere.
Comment by HarisF1 posted on KS2 dark images with Live View at 14/12/2020 - 20:11
Comment by HarisF1 posted on Bit worrying...... at 13/12/2020 - 19:41
I'm looking for a fully dead one to be honest as it'll be a bigger challenge (and hopefully cheaper). I managed to revive a 'creeping' SDM and got it fully working with no massaging required so I'm keen on seeing how the same method works.
Essentially I am lubricating the SDM unit and then flushing it, hopefully to remove any residue that is causing the failure.
Comment by HarisF1 posted on WTB: DA*16-50 or DA*50-135 with SDM failure at 26/11/2020 - 15:03
I'm looking to buy a copy of one of the above that is suffering from SDM failure. The reason for this is that I've been looking into repairing the SDM unit itself and I'd like to have a go.
The lens itself must be in good optical and mechanical condition with a faulty (but not damaged/repair attempted) SDM unit.
Cheers!
Comment by HarisF1 posted on WTB: DA*16-50 or DA*50-135 with SDM failure at 25/11/2020 - 19:10

