pentaxian450

Joined: 10th February 2008

All Forum Comments

Topics Created Topics Contributed Forum Comments Photo Comments

All Forum Comments

pentaxian450
Chromatic aberration (fringing) is something that appeared with the digital camera era.

Films contains three different layers which are sensitive to the three colors used to reproduce the spectrum we are able to see. These three layers are superposed in such an order as to compensate almost perfectly for the different wavelength focus point.

Unfortunately, the Bayer type sensor used in almost all cameras has only one layer, so different color wavelength have to focus at the same distance from the lens entrance pupil. This is the main source of color fringing.

Color fringing hardly shows up on a Foveon sensor due to it's three different color layers that acts like the films used with silver based color emulsion.

Comment by pentaxian450 posted on Chromatic aberration/ the fringe at 09/01/2017 - 02:43

pentaxian450
If you go in a specialty store that caters to the disabled person, get an "anti-slip placemat". You just put your lens/filter combo on it, with the filter in contact with the placemat. Then, applying light downward pressure on the lens, unscrew it. The thing is so "grabby", nothing will slip on it. Works all the time.

Comment by pentaxian450 posted on Tuesday Teaser at 21/12/2016 - 01:58

pentaxian450
I like the "atmosphere" of the first two pictures, but, to me, they look over-sharpened. Maybe softening them a little bit would suit the subject better. And then, maybe it's just me...

Comment by pentaxian450 posted on Three from Today at 15/12/2016 - 03:01

pentaxian450
If you try using LED lighting, make sure the LED lights are full spectrum, otherwise you could end up with strange colour cast that are very difficult to correct.

Comment by pentaxian450 posted on Product photography set up. at 25/11/2016 - 00:38

pentaxian450
[quote:3496ace15f="McGregNi The risk of using an auto-exposure mode is that once the filter is in place, a re-metering might occur messing up your nice ground exposure.[/quote]If you meter for the ground, and you know for sure the sky is two stops brighter than the ground, then you could use any auto exposure mode to shoot with the ND filter and the exposure would be all right. But if the difference between highlights and lowlights is not as you think it is, then all bets are off.

Comment by pentaxian450 posted on SILLY QUESTION at 25/11/2016 - 00:35

pentaxian450
The DA 12-24 f4 also has a baffle...

Comment by pentaxian450 posted on DA* 60-250 Modification for Full Frame at 02/07/2016 - 15:31

pentaxian450
You could also go for the K3 II. The focusing ability in low light is probably the best of any APS-C camera. As for focusing speed, the Pentax DA* in lens motor is rather slow. If you use Sigma or Tamron lens with in-lens motor, they are faster than the Pentax DA*. The newer Pentax lenses with DC motor are better in that regard than the DA* lenses.

Comment by pentaxian450 posted on K1 autofocus speed at 02/07/2016 - 15:10

pentaxian450
I wish you a speedy and full recovery.

Unfortunately, as I write this, my wife is in the hospital's psychiatric ward.

Health problems can put such a big damper on so many activities. Hopefully, you'll be back soon, and you can enjoy all the things you like again.
Keep in touch.

Comment by pentaxian450 posted on Time out for me at 02/07/2016 - 14:52

pentaxian450
The Pentax DA 12-24 is shorter at 18 than 12 or 24mm.

It all depends upon the type of lenses used and their location within the objective.

Comment by pentaxian450 posted on SMC DA 18-55mm Zoom at 05/06/2016 - 03:50

pentaxian450
Rabski wrote:
Full frame will inherently be better for low light.
Not always. If you had a FF with the same pixel size and ratio as the K3, the low light results would be quite similar (barring any change in the camera processor).

Comment by pentaxian450 posted on K-1 Dynamic Range at 14/05/2016 - 11:04

Proudly supporting Pentax User

Samsung Logo Asahi Pentax Logo