All Forum Comments
Comment by Anvh posted on older Prime vs newer Zoom at 17/07/2011 - 19:39
I'd want to see it in action to see whether it can actually reach all of the camera functons.
So you must shoot in auto mode if you like it or not.
Comment by Anvh posted on Decent underwater housing at 17/07/2011 - 18:45
It's an electronic instruction to a mechanical device. There must be feedback to say "I've arrived at the point of focus" but of course there will be mechanical tolerances.
How does the lens say it has got there? Surely the camera decides when focus is achieved, and the lens is only responding to instructions from the camera via mechanical coupleing ( electrical with SDM )?
1. AF reads the focus error
2. estimate the amount the AF needs to move and estimate the number of turns of the AF motor
3. When motor has done his job, the AF module check again and either says it's on focus or try to estimate the number of turns it needs to get the focus.
So it goes on and on till the AF sensor say it's in focus.
Even if the lens or motor overshoot, the sensor will say it's out of focus and will try to get the focus right.
ps. Pentax does even do a double focus check by slightly moving the lens out of focus and back on focus again when after the first focus lock.
Comment by Anvh posted on Sigma 50 1.4 from Microglobe at 17/07/2011 - 18:26
Comment by Anvh posted on Sigma 50 1.4 from Microglobe at 17/07/2011 - 18:01
Guess
Comment by Anvh posted on Your Avatar at 17/07/2011 - 17:53
Unfortunately, according to various testers there are focus problems with this lens too. Must be something to do with the wide aperture, I suppose.
http://toothwalker.org/optics/spherical.html
Comment by Anvh posted on Sigma 50 1.4 from Microglobe at 17/07/2011 - 17:38
I chosed the avatar because he looks like me and has this wise-ass pose.
Maybe i should update mine...
Comment by Anvh posted on Your Avatar at 17/07/2011 - 17:20
There are some margins build in the lens and the AF sensor of the camera so the tolerances aren't 100% meaning the lens might front or back focus.
I've checked my lenses and they all needed some correction to make them focus correctly with the AF sensor of the camera.
Live view works differently, it use the actually image to verify focus so it bypass all those tolerances by looking at the final image.
So to show the differences you're doing here, focus first with live view since that one is the most accurate and set the lens to MF so that the camera doesn't focus any more.
Then take a photo with live view and then one without live view while leaving the lens on MF, that should deal with the variation of the focus in your photos.
Comment by Anvh posted on KR Live veiw v Through the lens at 17/07/2011 - 17:11
"Evolution" is invariably the result of mistakes made by the semi-literate.
Maybe the old ways are much better, far simpler to just speak one language, it's after all one Europe right?
Comment by Anvh posted on Twitter spellings test at 17/07/2011 - 16:46
If it helps the clock was taken about 3 foot focus on the ctr winder. The garden photo focus point was on the left pillar at the front edge of the capping stone about 10 feet away.
Regards Ian
Have you ever checked if your focus is spot on when using the viewfinder?
I don't see the distances involved here as "short distances" Stefan.
Comment by Anvh posted on KR Live veiw v Through the lens at 17/07/2011 - 16:41

