All Forum Comments
Comment by thingsthatihaveseen posted on Seasonal Greetings at 23/12/2013 - 14:30
Best
Comment by thingsthatihaveseen posted on What are K-01 users using with their cameras? at 27/11/2013 - 17:40
Best
Comment by thingsthatihaveseen posted on Pentax F 70-210mm for an occasional use longer option? at 18/11/2013 - 22:49
Best
Comment by thingsthatihaveseen posted on Another Aurora Timelapse at 17/11/2013 - 22:38
Thanks again for your help...
Best
Comment by thingsthatihaveseen posted on Ghosts II at 13/11/2013 - 14:25
Also the conditions I usually shoot in tend to be pretty tricky due to seaspray etc, hence the use of the UV filter in the first place to:
a) Keep sea spray off the lens
b) Make it easier to clean fast
c) Make it easier to swap out with a replacement when there's too much
salt built up on it to shoot (there comes a point where however much
you clean it there's still a layer of salt left on it)
But I take your point... will try shooting without one whenever possible...
Thanks again...
Best
Comment by thingsthatihaveseen posted on Ghosts II at 13/11/2013 - 13:16
Or if light is actually going through the filter and bouncing off the lens onto the BACK of the filter during a long exposure, is there much I can do about it at all? Would it be better to remove the UV filter altogether?
Would be interested to know your thoughts...
Best
Comment by thingsthatihaveseen posted on Ghosts II at 13/11/2013 - 10:10
Best
Comment by thingsthatihaveseen posted on Ghosts II at 12/11/2013 - 19:50
Kingalew's recent post re ghosts reminded me of a problem I encounter every now and again...
If I have the sun top left of frame, either just in or just out of the frame, I sometimes get circular ghosting in the bottom right, or more occasionally top right of the photograph.
Below are a couple of unedited shots with the contrast pushed to show the problem:


It doesn't happen all the time, but it does specifically seem to happen on long exposures.
I use a K5 with a Sigma 10-20, slimframe Hoya UV filter, Lee wideangle filter holder, Lee 10 stop filter, and Lee grad on the outside...
My best guess so far is light somehow getting caught inside the set up and bouncing off a filter rim or something somehow (I can't use a hood on the lens due to the filters) ...
I'd be really very grateful if:
1. Anyone could help explain what is actually occurring here?
2. Anyone could help with a suggestion of how I might fix it?
Like I say it doesn't happen very often, but often enough to wish it didn't...
Thanks very much in advance...
Best
Comment by thingsthatihaveseen posted on Ghosts II at 12/11/2013 - 19:05
Best
Comment by thingsthatihaveseen posted on 'Welcome to the Edge' at 09/11/2013 - 22:45


Best