terje-l

Joined: 25th December 2007

All Forum Comments

Topics Created Topics Contributed Forum Comments Photo Comments

All Forum Comments

terje-l
The weather was not the best, but I still feel a certain mood in this picture of the Storebelt bridge, taken on a recent trip to Denmark.

Comment Image


Taken at 1/350 f/8 with the 18-55 mm kit lens at 33mm
C&C appreciated, thanks!

Comment by terje-l posted on Moody Bridge at 26/02/2008 - 09:37

terje-l
Oh dear - if one wants to be pedantic about definitions then my setup is not wireless, at least not as per George's terms. To me it is, because I can trigger my external flash without cables (= wireless).

So what if it's not 21st century technology. What is wrong using one's brains to do some calculations? You soon get the hang of it, so there will be less trial as experience grows. This reminds me of the youngsters in supermarket cash points, who are unable to give back the correct change unless the cash register does the calculation for them. Guess I'm getting old...

And, Mannesty, it is controllable, i.e. the results are the same every time. It is just a question of guide numbers and distance, right?

There are several advantages having an original flash like the AF360. Used on the camera, which I suspect is the majority of occasions, one has the benefit of full P-TTL control. For the few cases one wants to do something different, one can detach the flash and use the dumb slave mode without searcing for that little light sensor (which seems to have disappeared when you really need it).

IMHO the K100D/AF360 combination is a good compromise from both a financial and practical point of view.

This concludes my contribution to this thread, I just want to thank you, gentlemen, for an interesting discussion.

Comment by terje-l posted on Very confused.. at 24/02/2008 - 20:50

terje-l
The AF-360 was set to Wireless On (middle position of power switch), with the slave mode to 2 (dumb slave). The slave mode switch was set to S. This brings the flash up in Auto mode, but you may switch between Auto and Manual. Manipulating the f-stop and ISO settings will control the flash output.

The camera (K100D) was set to P for this test, giving an exposure of 1/60 f/4.5, and the internal flash was popped up manually.

I believe the pre-flash is fired either as a red eye reduction or as a focusing aid in low light levels, otherwise not. So the secret is to switch off red eye reduction and use manual focus. That should prevent pre-flash.

Of course, in good light conditions auto focus can be employed.

As I mentioned in my previous post, some experimenting may be required to achieve the correct exposure, since its all manual work.

Comment by terje-l posted on Very confused.. at 24/02/2008 - 14:21

terje-l
Mannesty,

I appreciate your considerations. However, the original question from ikillrocknroll was
Quote:
Is there any way you can just hold the flash wireless (to get a different angle for the flash) or do you have to have a slave Or would I need to buy the hot shoe adapter and cord (around £60 )
and the answer is yes, you can.

You are correct in saying that the P-TTL will not work, it will only be a simple dumb slave. But for those who cannot afford a K10D or two extra flashguns, it is a reasonable alternative.

I am easily provoked so I have to prove my point with some test shots:

The flash fired both when pointed at (left) and in the mirror (right).
Comment Image


The left picture is taken with pop-up flash only, the right with the AF360 hand held a little to the left of the camera. The shadows indicate that the AF360 did fire.
Comment Image


Of course you cannot use preflash, so manual focus may be necessary in darkish conditions, and red eye reduction is out.

Seeing your impressive list of equipment, and your high number of posts, I realize that I am just a simple amateur in comparison, but I still believe that I have a point...

Comment by terje-l posted on Very confused.. at 24/02/2008 - 11:52

terje-l
George,

With my K100D the AF360 does work as a slave, triggered by the pop-up flash. If you read pages 50-51 in the manual you will see that the AF360 has a built-in sensor for slave work.

You will not get the full automatic wireless communication as with the K10D, but still usable, although more manual thinking is involved.

Comment by terje-l posted on Very confused.. at 24/02/2008 - 00:05

terje-l
The AF-360FGZ does work as a slave flash, triggered by the light from the on-camera flash. So you can hold it in your hand to get some side light.

Set the on-off switch to the centre position, marked wireless, and set the wireless mode switch to S (slave). The flash will be in the Auto mode, and you can modify both the F and ISO settings to control the light output.

With the proper adjustments, the 360 will act as your main light, with fill-in from the pop-up flash.

Obviously, a few test shots may be required, but that is the beauty of digital photography: Experimenting is free, and with immediate results.

Comment by terje-l posted on Very confused.. at 23/02/2008 - 22:03

terje-l
They say that all good things in life are free, perhaps this does not apply to computer software.

When it comes to CD and DVD burning software I wouldn't trust freeware, but get a professional package like Nero Burning ROM or Roxio Easy Media Creator. After all, making backups is serious business, whether it is picture files or other documents.

Symantec's Norton Ghost is another alternative for backing up the whole disk.

Comment by terje-l posted on Can't find good DVD burning software at 27/02/2008 - 08:01

terje-l
Nobody so far seem to have mentioned that the camera can save to jpeg in three different levels of compression. I think it is fair to state that to keep quality up, one should make sure that the highest jpeg quality is selected in the camera.

So far I haven't got used to the RAW format, but I appreciate the advantage of the 12 bit depth for editing. Personally I could not afford the extra storage space needed for RAW or TIFF for other than selected pictures, shooting and saving the family snapshots, etc. in jpeg. And then I normally use a quality setting of 10/12 when saving to disk. That means a factor 1/5 in storage space.

Having said that, I feel that MattMatic gave a very clear definition of the different formats a few posts above.

Comment by terje-l posted on RAW to TIFF at 26/02/2008 - 20:53

terje-l
... is a maritime site. Therefore I found it appropriate to enter a picture of the lighthouse welcoming you to the pleasure boat harbour.

Comment Image

Comment by terje-l posted on Weekly Competition No. 33: "My Town . . . . ." at 24/02/2008 - 12:06

terje-l
Just lightened shadows by 20% and added sharpness by 10%, no change to colours. It lastet just a few minutes, though, shot from my garden.

Comment by terje-l posted on Sunset in Horten at 18/02/2008 - 21:56

Proudly supporting Pentax User

Samsung Logo Asahi Pentax Logo