richandfleur

Joined: 3rd December 2012

All Forum Comments

Topics Created Topics Contributed Forum Comments Photo Comments

All Forum Comments

richandfleur
As above, the shutter speed is critical, unless you can somehow manage it for artistic effect.

Do what you've got to do to get the shot. Be that widest available aperture, slowest shutter speed to still get a sharp image, and highest ISO required, assuming flash is not an option.

Plan B is to try to use the available environmental lighting, stage lights, flashing lights etc to your advantage.

If it all fails, then black and white the end result, as colour noise can look ok a sort of film grain effect.

Comment by richandfleur posted on Wish me luck at 31/01/2016 - 23:33

richandfleur
Jonathan-Mac wrote:


A new top-spec APS-C model would be good later on to reassure customers that APS-C is still very much a part of the plan, even for "pro" models.
Yes Pentax has traditionally been very strong in this arena. Now that others have updated their offerings Pentax needs to return strong again.

Comment by richandfleur posted on New K-3 III Coming at 27/01/2016 - 21:52

richandfleur
Well there weren't many rumours for long about the coming FF before it was confirmed, so I'd totally buy in to any new Pentax camera suggestion unreservedly...

Comment by richandfleur posted on New K-3 III Coming at 26/01/2016 - 23:31

richandfleur
#2 and #4 for me.

Comment by richandfleur posted on garden birds at 17/01/2016 - 21:13

richandfleur
Algernon wrote:


Just imagine if Pentax did similar with the FF camera instead of a rugby team

PENTAX FULL FRAME 2016 Shall we begin...... I have returned

https://www.youtube.com/watch?v=H5kX51J4hjo

--
Oh yes

Comment by richandfleur posted on Full Frame Teasers at 17/01/2016 - 18:38

richandfleur
On the flip side, how common were these lens motor drive failures, and what did Pentax do about them?

I've never heard of mirror flap on the K-5 series, but with the advent of youtube, I've seen it on the K-3, and it looked nasty. Pentax never really addressed the root cause of this, releasing a firmware that identified it was happening and pulling the power for you.

The Aperture motor failure on the K-30/K-50 range has been unfortunate, with Pentax being noticeably absent for any of these that fail outside of warranty periods. It's clear there is a faulty part in these, but there's no avenue to raise this with Pentax themselves, only via the store you purchased it from.

And from memory some sensors developed green lines through them, something like that?

All up that's not a lot of failure points really, and I'm sure that compares to other brands. My personal point of view though is that it's not necessarily if something fails, but more how the company deals with these problems. Not sure I'd rate Pentax particularly well at that latter point...

Comment by richandfleur posted on Camera of the year! at 16/01/2016 - 20:26

richandfleur
Pentax the company is essentially unreachable. It's almost as if they don't exist.

As above, slack support to the dealer from Ricoh is the dealers problem. The dealer should sort your issue, given that's where you paid your money. I don't know what the UK setup is, but here in NZ you are covered by a consumer guarantees act, which basically says goods should work for 'an acceptable' period of time. That's clearly ambiguous, but it usually falls in favour of the consumer.

I do think Pentax have a long way to go in terms of customer service (having been through a K-30 Aperture Motor failure), and post purchasing support (firmware updates with new features to keep your camera current where possible).

Comment by richandfleur posted on Ricoh Pentax awful customer service at 14/01/2016 - 20:02

richandfleur
McGregNi wrote:
We need a good 'tutorial' on it then ....'A Method of Applying Gut Instinct' .....
Lol, same way most people get it I expect. Go out shoot lots, stuff up shots, work out why, repeat until getting better

http://youtu.be/ZFteoCptzvM

Comment by richandfleur posted on Anti aliasing simulator filter at 14/01/2016 - 05:55

richandfleur
pentaxian450 wrote:


P.S. Sometime, when reviewing image on the rear screen, some moire will show up because the screen resolution isn't high enough. It doesn't mean moire will show up on the picture.
Exactly. And vice versa I presume. I expect you'd need to zoom to 100%, if that is an option on the rear screen? (- from memory it goes to a max of 16x zoom, but I don't know if that equates to 1:1?), and then pan around the image looking for moiré ...

You're quite limited really, and presumably need to go on gut instinct and assessment of the subject matter. I like that it's an option, but I do think it's over hyped to promote a point of difference at release time. Personally I'd rather them take that sensor shift tech and use it to stabilise during video mode...

Comment by richandfleur posted on Anti aliasing simulator filter at 14/01/2016 - 01:04

richandfleur
Personally I see it as a gimmick, intended to offer a point of difference. I expect it to almost never be used on most cameras with the function.

As John mentions the cameras are now pretty darn good, so moiré doesn't appear to be a common problem as much any more. And as Nigel points out, it's often extremely difficult to predict the occurrence, so most often it will be spotted to late to retake the shot.

Personally I find there are tools to deal with it (to some degree) in post, available via the likes of Lightroom or more manually via photoshop, so I'd take my chances with it off. The exception being that one time you get a job to photograph lace curtains or pin stripe shirts etc,

Comment by richandfleur posted on Anti aliasing simulator filter at 13/01/2016 - 19:48

Proudly supporting Pentax User

Samsung Logo Asahi Pentax Logo