All Forum Comments
Comment by Frogherder posted on Another pointless thread at 23/02/2012 - 23:00
Bernard
Comment by Frogherder posted on Pentax at Focus on Imaging 2012 at 23/02/2012 - 18:04
Bernard
Comment by Frogherder posted on Extention Tubes at 22/02/2012 - 22:45
I had the same problem with a hemp cord that I started with (rope dia is 1/4"by the way).
When the hook is down and loaded it's not to bad, just a bit of spin as the load twists (puts about 10 turns on the load, but the rope slides past itself)
With no load it just spins up and I can't lower an empty hook, followed by complete jam up if I persist.
I've unthreaded the rope from the pulleys, stretched it out down the garden, getting rid of any surplus twist. On re-threading through the pulleys it works once or twice then..............
Bernard
Comment by Frogherder posted on Another pointless thread at 22/02/2012 - 22:44
Try this site you may find help ?
link
search for Handy Billy
Lots of info on block and tackle even mentions the loss due to friction of the sheeves 1/10 IIRC
Bernard
Comment by Frogherder posted on Another pointless thread at 22/02/2012 - 15:38
Anyone know how to stop rope twisting up as it goes over a pair of pulleys.
Bernard
Comment by Frogherder posted on Another pointless thread at 21/02/2012 - 23:08
Bernard
Comment by Frogherder posted on Another pointless thread at 20/02/2012 - 16:55
(memories of Jungle Book have just surfaced)
Not that I'm infering that you're from Liverpool
Bernard
Comment by Frogherder posted on Another pointless thread at 20/02/2012 - 16:21
I was just amused (not really the word I want) by what some people do for a job.
regards
Bernard
Comment by Frogherder posted on Another pointless thread at 20/02/2012 - 15:56
Comment by Frogherder posted on Pentax k100D battery door broken. Best solution to repair? at 20/02/2012 - 15:42


Bernard, could you not, when the ropes/pullies are not loaded/in use, put a temporary load on, a small sandbag perhaps?
That way, the system will always "think" it's loaded......
Roger.
The system is for hauling timber into my workshop loft. Max load 30-40lb, but more than I fancy whilst climbing a ladder. Unloaded it lives in the roof space and it bugs me that I have to climb into the loft to bring it down then back up again when I'm ready to haul up. The when finished get it back up again whlst it's trying to twist up. I tried to get woven rope (climbers stuff) but I need 1/4 diameter to fit the pulleys.
Bernard