All Forum Comments
Comment by Frogherder posted on How to clean your sensor at 10/10/2011 - 23:06
I have a AF240Z and a AF260As each mounted on an Ishoot radio receiver.
The radio transmitter is mounted on my K10D which is set to X.
If I switch off the left hand flash, the right hand one always fires and vice versa, and gives the effect shown in my avatar
If I switch both on sometimes the left fires and not the right, sometimes it's the otherway round. It's almost as if they don't like each other. But occasionally (about once in eight) all works fine
I'm running the AF240Z flash gun in manual and I've tried covering both the sensors with black tape. All batteries are fully charged. Exposure is about right when both fire (ok on the side of the flash when only one fires)
Any ideas about what might be going wrong would be most welcome
Bernard
Comment by Frogherder posted on Problem with two flash guns at 10/10/2011 - 22:53
Bernard
Comment by Frogherder posted on How to clean your sensor at 10/10/2011 - 19:44
Bernard
Comment by Frogherder posted on Prohibition of photography at 10/10/2011 - 16:41
Comment by Frogherder posted on How to clean your sensor at 10/10/2011 - 16:37
see http://www.eryri-npa.gov.uk/a-sense-of-place/60-Wonders
Bernard
Comment by Frogherder posted on Countryfile at 10/10/2011 - 16:11
Maybe a letter to our respective MP's; Police Chiefs (there are bound to be others that could be added) outlining the problems faced and asking for a review of the situation might better suit the bill.
Bernard
PS There are also busybody's who take it upon themselves to "police" the streets in the lookout for paedophiles with DLSRs and Telephotos
Comment by Frogherder posted on Prohibition of photography at 10/10/2011 - 15:35
Bernard
Comment by Frogherder posted on Countryfile at 10/10/2011 - 11:31
Bernard
Comment by Frogherder posted on Just a thought at 08/10/2011 - 23:07
Surely if porosity was a problem then gas would leak in (it does very very very slowly and the valves eventually cease to work. Note also that the glass in valves is less than 10thousand of an inch - not the thickness of lens glass)
My point is that if the pores are so small then dust would not be absorbed into the surface
Bernard
Comment by Frogherder posted on Lens Cleaning at 08/10/2011 - 23:04


Even my Tshirt (usually filled with sweaty woodflour) wouldn't manage that
Bernard