K-5 Anti Shake

johnriley
Posted 14/06/2011 - 21:51 Link
Except that you can't guarantee that any hand held speed will be fast enough. We shake. A fast enough shutter speed will mean an acceptably sharp image, but in the end the only really sharp image will be on a tripod.

That's not to say that we can't hand hold, but it's not as predictable. For this reason I always take more than one shot. Compare three shots and one will be the best, at any shutter speed.

But don't take my word for it, try it.
Best regards, John
johnwhit
Posted 14/06/2011 - 21:51 Link
Hi Stefan,

I was referring to a multiplier for the focal length, if SR thinks you're using a 300mm lens when in actual fact you're using a 420mm, 450mm or 510mm lens it can hardly be optimal.

Either that or give us a 400mm f/5.6 SDM or better, or produce the SDM 1.4x TC that was rumoured and have that set SR to 420mm and while they're at it have it display the correct aperture value in the VF.

John
PPG link

In LBA hiatus.
bforbes
Posted 14/06/2011 - 22:00 Link
Using a DA300/Pentax 1.7x combination on the K5 I have to "Input Focal length". So does the SR not just use what you input?
Edited by bforbes: 14/06/2011 - 22:01
Smeggypants
Posted 14/06/2011 - 22:16 Link
Mannesty wrote:
Smeggypants wrote:
Mannesty wrote:
If you suspect that SR not being stabilised may be the cause of images apparently having camera shake, run them through PhotoMe and look for the two entries "SR Result" and "Shake Reduction (Setup)" under the Manufacturers notes section.

"SR Result" should show "Stabilised", and "Shake reduction (Setup)" should show "On".
hmmmm. checked both pics and they both show stabilised. one pic clearly isn't
Now that you know that SR was not to blame, you need to start looking at other causes, like: Shutter speed too slow or, subject moving too fast or, operator really should not have gone to the pub before the event.
I don't know SR was not to blame yet. Subjects standing still and shutter speeds were high enough. 1/1000th sec on 50mm lens in one case.

Frankly I wouldn't have started this thread had the problem been on pics with a slow shutter speed and/or moving subject.


There could be a firmware issue with the K-5 where it write stabilised in EXIF when it isn't. More more research required definitely.

Interestingly I'm looking through some other EXIFs and I'm seeing "Not ready" and "Not stabilised" - "Shake Reduction (Setup)" is either 7 or 4. I believe 7 is on and 4 is off ??

Anyway I'm certainly not coming to any firm conclusions solely based upon what PhotoMe says....
[i]Bodies: 1x K-5IIs, 2x K-5, Sony TX-5, Nokia 808
Lenses: Pentax DA 10-17mm ED(IF) Fish Eye, Pentax DA 14mm f/2.8, Sigma 17-70mm f/2.8, Pentax-A 28mm f/2.8, Sigma 30mm F1.4 EX DC, Pentax-A 50mm f/1.2, Pentax-A 50mm f/1.4, Pentax-FA 50mm f/1.4, Pentax-A 50mm f/1.7, Pentax DA* 50-135mm f/2.8, Sigma 135-400mm APO DG, and more ..
Flash: AF-540FGZ, Vivitar 283
Smeggypants
Posted 14/06/2011 - 22:30 Link
bforbes wrote:
Using a DA300/Pentax 1.7x combination on the K5 I have to "Input Focal length". So does the SR not just use what you input?
It should do AFAIK
[i]Bodies: 1x K-5IIs, 2x K-5, Sony TX-5, Nokia 808
Lenses: Pentax DA 10-17mm ED(IF) Fish Eye, Pentax DA 14mm f/2.8, Sigma 17-70mm f/2.8, Pentax-A 28mm f/2.8, Sigma 30mm F1.4 EX DC, Pentax-A 50mm f/1.2, Pentax-A 50mm f/1.4, Pentax-FA 50mm f/1.4, Pentax-A 50mm f/1.7, Pentax DA* 50-135mm f/2.8, Sigma 135-400mm APO DG, and more ..
Flash: AF-540FGZ, Vivitar 283
johnwhit
Posted 15/06/2011 - 07:30 Link
bforbes wrote:
Using a DA300/Pentax 1.7x combination on the K5 I have to "Input Focal length". So does the SR not just use what you input?
It's not possible as all Teleplus TC's just throughput the lens data and "Input Focal Length" is greyed out in the menu. The Pentax 1.7x must be unique, it was designed for older manual lenses.

John
PPG link

In LBA hiatus.
Algernon
Posted 15/06/2011 - 10:44 Link
Yesterday I used the Sigma 150-500mm with the in lens SR on and I forgot to turn off the SR on the K-5..... so both SR systems were ON!

It doesn't seem to have caused any problems the shots are as sharp as they usually are
Half Man... Half Pentax ... Half Cucumber

Pentax K-1 + K-5 and some other stuff

Algi
simonkit
Posted 15/06/2011 - 16:51 Link
johnwhit wrote:
Pentaxophile wrote:
And wouldn't it be great to have an external antishake on/off switch?
I knew I could find another reason not to upgrade yet and just found it

John
I don't miss it myself as I was always catching it accidentally on the K20D, to be fair it's not too difficult to switch SR on/off using the info button and selection keys. Infact I really like the new "setup" screen that they've added to the LCD - very useful

.
Edited by simonkit: 15/06/2011 - 16:52
johnwhit
Posted 15/06/2011 - 18:19 Link
I'd prefer to be able to do it with my eye still at the viewfinder, it's probably possible but not to intuitive using the info button and menu.

John
PPG link

In LBA hiatus.
Edited by johnwhit: 15/06/2011 - 18:19
TiffRaw
Posted 17/06/2011 - 16:21 Link
I am not an expert, this is just an observation. As I understand it, 'anti-shake' is essentially a control system that senses vibration and responds by dampening the effect of the movement on the sensor. Sounds strange but if no vibration is present, the anti-shake control system inherently induces a movement so that it has something to compare to a null signal. Hence, when anti-shake is not required (perhaps on tripods or fast shutter speeds and/or shorter focal lengths) it should be turned off otherwise it actually makes things worse. The problem of course is that a 'grey area' will always exist in which there is no fine demarcation between when it is and isn't needed. This is probably the cause and effect of all anti-shake systems, not just the K5's.
Algernon
Posted 17/06/2011 - 16:46 Link
Extensive scientific tests were done on the K-7 anti-shake by Lumo Labs on the US forum and papers published... apart from a small problem with wide angle lenses at around 1/100th sec. everything worked quite well
Half Man... Half Pentax ... Half Cucumber

Pentax K-1 + K-5 and some other stuff

Algi
Mannesty
Posted 18/06/2011 - 13:40 Link
Smeggypants wrote:

Interestingly I'm looking through some other EXIFs . . . "Shake Reduction (Setup)" is either 7 or 4. I believe 7 is on and 4 is off ??
The latest Beta version (2009) will show this parameter as "On" or "Off".
Peter E Smith - flickr Photostream
Algernon
Posted 18/06/2011 - 13:57 Link
When using Photome use "Update Now" to make sure that the db is up to date.
Half Man... Half Pentax ... Half Cucumber

Pentax K-1 + K-5 and some other stuff

Algi
Algernon
Posted 18/06/2011 - 15:02 Link
If you type shape in the filter box in PhotoMe it gives the following additional information:

SR Result = stabilized
SR (setup) = On
Shutter release half press time = 4.25 secs
SR Focal length = 404mm

Strangely the SR Focal length varies slightly from the focal length
reported elsewhere.... no idea why?
Half Man... Half Pentax ... Half Cucumber

Pentax K-1 + K-5 and some other stuff

Algi
Smeggypants
Posted 18/06/2011 - 19:44 Link
Algernon wrote:
When using Photome use "Update Now" to make sure that the db is up to date.
I was sure I updated not so long ago. Just tried again to make sure I haven't missed any newly released updates and it said

""You are already using the latest version of Photome - there are no other updates available.""

About: Version 0.79R17 ( build 856 )

hmm?
[i]Bodies: 1x K-5IIs, 2x K-5, Sony TX-5, Nokia 808
Lenses: Pentax DA 10-17mm ED(IF) Fish Eye, Pentax DA 14mm f/2.8, Sigma 17-70mm f/2.8, Pentax-A 28mm f/2.8, Sigma 30mm F1.4 EX DC, Pentax-A 50mm f/1.2, Pentax-A 50mm f/1.4, Pentax-FA 50mm f/1.4, Pentax-A 50mm f/1.7, Pentax DA* 50-135mm f/2.8, Sigma 135-400mm APO DG, and more ..
Flash: AF-540FGZ, Vivitar 283

Add Comment

To leave a comment - Log in to Pentax User or create a new account.



Proudly supporting Pentax User

Samsung Logo Asahi Pentax Logo