All Forum Comments
Comment by Yorkie posted on May I ask for some guidance please at 29/12/2023 - 14:46
Comment by Yorkie posted on May I ask for some guidance please at 29/12/2023 - 14:32
I am far too long in the tooth to get into the all-singing and dancing modern versions and all I need is decent autofocus, shake-reduction capabilities and image quality commensurate with age. Of course price is a major factor so I am looking for a camera/short zoom lens combination coming in at around £500 or less. I have trawled the net and I have seen a number of attractive offers but my lack of knowledge leaves me somewhat vulnerable
This is probably wishful thinking on my part, however I can think of no better place to ask for guidance than the collective advice here in the forum, so thanks in advance for your time and wisdom.
Comment by Yorkie posted on May I ask for some guidance please at 29/12/2023 - 14:18
Comment by Yorkie posted on Bradford on Avon at 17/06/2023 - 09:26
Comment by Yorkie posted on Mint MZ5 15 rolls gone through it at 31/05/2023 - 10:32
https://www.sendeancameras.co.uk/camera-repairs#analogue-info
or
https://www.cameratiks.co.uk/repairs
or
https://www.simonwhitehead.photo/camerarepairs
Comment by Yorkie posted on Pentax MX seal and foam replacement at 20/03/2023 - 12:37
[quote:3496ace15f="Jonathan-Mac"]I understand that 220 backs can be easily converted to 120 backs. I only have a single 120 back so it's not an issue for me (though I have some 220 film I can currently only use in my 124G).
I know this is an early post but I have successfully converted a 220 to a 120 insert. Very easy and works perfectly. 220 inserts are cheap on ebay
If you compare the pressure plates of the 120 and 22 inserts side by side you will see that the 220 pressure plate is relieved (cut away) a small amount on the outside edges. This is to allow the pressure plate to bear on the film instead of the paper backing and locate the film securely in the proper plane. With a 120 insert the pressure plate presses the backing paper onto its proper rails above and below the film gate whilst the film is located correctly on its rails by the backing paper.
Essentially, unless the backplate is modified: a) the film will not be held in the correct plane and b) it will place undo stress on the winding motor assembly and it this breaks you have an expensive door stop as I have never found anyone who repairs them,
I discovered this years ago but recently found this post which explains it more clearly:
https://www.rangefinderforum.com/node/4763083
Comment by Yorkie posted on 220 B&W Film at 22/12/2022 - 11:44
Comment by Yorkie posted on For sale: Tripod quick release fitting at 19/12/2022 - 12:25
Comment by Yorkie posted on For sale: Tripod quick release fitting at 07/12/2022 - 14:50
Comment by Yorkie posted on Film developers at 13/11/2021 - 11:27





