Hello everybody - I'm new to the board, but I've been taking photos for over 50 years. And after doing lots of digital, I'm playing with film again.
Have just received my first set of Provia 100F slides taken on the "new to me" MZ-M*. As it was a S/H body, I shot a variety of subjects and tried changing the film speed setting from the nominal 100 to 160, and also to 200. Spread out on the A3 lightbox I've rarely seen such a uniform set, well exposed with good colour and saturation. I did try reducing exposure by 1/2 stop using the L/H control, and that change was clearly noticeable.
So my question is, does the MZ-M ignore changes to the ISO setting when a DX coded film is loaded? The top-plate window showed "ISO" whenever the camera was not set to the DX coded value, so I assumed that this was a mild warning that changes to exposure were being made, and the viewfinder read-out appeared to confirm this.
* I bought this camera because my ME-Super only does whole stop exposure compensation and that's too coarse for slide film.
Have just received my first set of Provia 100F slides taken on the "new to me" MZ-M*. As it was a S/H body, I shot a variety of subjects and tried changing the film speed setting from the nominal 100 to 160, and also to 200. Spread out on the A3 lightbox I've rarely seen such a uniform set, well exposed with good colour and saturation. I did try reducing exposure by 1/2 stop using the L/H control, and that change was clearly noticeable.
So my question is, does the MZ-M ignore changes to the ISO setting when a DX coded film is loaded? The top-plate window showed "ISO" whenever the camera was not set to the DX coded value, so I assumed that this was a mild warning that changes to exposure were being made, and the viewfinder read-out appeared to confirm this.
* I bought this camera because my ME-Super only does whole stop exposure compensation and that's too coarse for slide film.
Pleased with my results but somewhat puzzled...