MZ-M ignores ISO change ?
Posted 09/04/2005 - 13:45
Link
There's a bit of a mixture of things there, but I'll try a few thoughts:
When you change the ISO speed from say 100 to 160 this is 2/3 stop under-exposure, but that could be well within the exposure latitude of your film. Over-exposure you would notice right away with slide film, but under-exposure only intensifies the colours until it become so severe that the shadows block up.
So it also depends upon the subject - the eye would be hard pressed to see differences in density of a grey card, for example, until quite a large difference occured. And then if the composition changed slightly from shot to shot the amount of sky, for example, might change the exposure anyway, so you would need a tripod mounted camera for a proper test.
In short, there are so many variables that you need to undertake a proper scientific approach to make meaningful deductions.
You can tell if the MZ-M is accepting the changes to the ISO setting by setting up the camera on a tripod, metering a grey card under controlled lighting and then changing the ISO significantly and metering again. You need to eliminate all the variables.
Having said that, if the slides looked OK, then they were OK....
When you change the ISO speed from say 100 to 160 this is 2/3 stop under-exposure, but that could be well within the exposure latitude of your film. Over-exposure you would notice right away with slide film, but under-exposure only intensifies the colours until it become so severe that the shadows block up.
So it also depends upon the subject - the eye would be hard pressed to see differences in density of a grey card, for example, until quite a large difference occured. And then if the composition changed slightly from shot to shot the amount of sky, for example, might change the exposure anyway, so you would need a tripod mounted camera for a proper test.
In short, there are so many variables that you need to undertake a proper scientific approach to make meaningful deductions.
You can tell if the MZ-M is accepting the changes to the ISO setting by setting up the camera on a tripod, metering a grey card under controlled lighting and then changing the ISO significantly and metering again. You need to eliminate all the variables.
Having said that, if the slides looked OK, then they were OK....
Best regards, John
Add Comment
To leave a comment - Log in to Pentax User or create a new account.


1 posts
21 years
Milton Keynes,
UK
Have just received my first set of Provia 100F slides taken on the "new to me" MZ-M*. As it was a S/H body, I shot a variety of subjects and tried changing the film speed setting from the nominal 100 to 160, and also to 200. Spread out on the A3 lightbox I've rarely seen such a uniform set, well exposed with good colour and saturation. I did try reducing exposure by 1/2 stop using the L/H control, and that change was clearly noticeable.
So my question is, does the MZ-M ignore changes to the ISO setting when a DX coded film is loaded? The top-plate window showed "ISO" whenever the camera was not set to the DX coded value, so I assumed that this was a mild warning that changes to exposure were being made, and the viewfinder read-out appeared to confirm this.
* I bought this camera because my ME-Super only does whole stop exposure compensation and that's too coarse for slide film.
Pleased with my results but somewhat puzzled...
Milton Keynes, UK