Thank you Flan and Rajhans, I have enjoyed it so far, luckily I don't have too many to copy!
But then I haven't sifted through all negatives yet, a lot of ,crap, ones...
Oh then the slides...

Static electricity at the moment, looking at alternatives tho.

Still playing, final ones honest, here is a real grainy one;

1.



2. One from June 2022 taken on the MX;



3. A quick dig pic, the setup, using a Peak Design travel tripod.

Agree with above comments, nice sequence and Thanks for sharing 👍

Well spotted!

Ditto

Thanks for the comments

Playing again with some old Negs this time using a new LED light panel/pad. (HSK Light Pad for £20)
Hopefully of interest to our Steam fans on here.

1.



2. Slight difference here of same shot, less detail as more Steam!



3.



4.

Mist-ifying... beautiful shots, well taken. Difficult to choose a favourite.

Thanks Stephen for the info and comments.

Flan, thanks for the useful advice, I'm still looking/researching/.....

Within RT In the profile tab click 'Bundled Profiles' and you will find PixelShift profile already set up.
Be prepared for rather large files, on the KP I have seen 125MB raw.

I have only only done a few trials with it however there are lots of help online, I have seen mention of saving the PP file as a 16 bit tiff but IIRC I've only done Jpeg. There is a way of tuning the Motion Correction somewhere too.

Flan said;
"It's great that one can convert older film negative or slide at home."

I copied the prints rather than the negs as my Ohnar slide copier will not hold the negatives. I'm sure I managed it once before but it's a problem from memory.

So I'm contemplating getting a flatbed light source and neg holder, I have just been looking at this;
https://www.amazon.co.uk/Rybozen-Ultra-Thin-Portable-Scanner-Negatives....
not bad for £23 but noticed one complaint that it didn't work on negatives!

Anyone with helpful suggestions? clean ones please.

Thank you guys for your comments, appreciated as always.