jeallen01

Joined: 12th February 2009

All Forum Comments

Topics Created Topics Contributed Forum Comments Photo Comments

All Forum Comments

jeallen01
CoDa wrote:
PM replied to
CoDa wrote:
PM replied to
Many Thanks sorted - see your PMs!

Comment by jeallen01 posted on A new tripod? at 29/03/2013 - 20:32

jeallen01
CoDa wrote:
Hi John,

I have a Redsnapper RS283 with the RS528 head which I do not use now. (CSC camera so light weight)

I have only used it about 6 times approx, I do have two quick release plates and the case with it.

I would sell this for £55.00 + P&P at cost.

Regards
Colin - sounds like a deal! Will PM you straight away!

Comment by jeallen01 posted on A new tripod? at 29/03/2013 - 16:07

jeallen01
Bump - anyone got any comments in response to my last questions below?
jeallen01 wrote:
Thanks for all the above replies - had never actually heard of Red Snapper tripods before, but having had a look at the website, I see what you guys mean.

Just looks like a matter of deciding which one to buy - in that context, does anyone have comparative experience of the 3 and 4 section Re 283 and 284 versions? (Apart from the lower retracted and extended heights, my guess is that the 3 section should be slightly more rigid because there are fewer sliding joints involved?)

OTOH, the RS 324 has the flip locks which I guess might be more postive (but it's also a fair bit heavier).

John

PS: Algernon & co, I see what you meant about not needing another head under the gimbal mount - thanks for that too.
Thanks in advance.

John

Comment by jeallen01 posted on A new tripod? at 29/03/2013 - 13:17

jeallen01
Quote:
Hullo jeallen, yes the thread on the Beike is 3/8 female Whitworth and if you remove your tripod head you should find a male 3/8 Whitworth thread on almost every brand tripod I`ve ever seen.
Simmo
Unfortunately not on my old Jessops tripod, you don't - just a cheap pan & tilt head.

Comment by jeallen01 posted on Advice on shooting flying aircraft. at 29/03/2013 - 13:12

jeallen01
gartmore wrote:
There was a time when just about everyone had one. I still have one that I used to use as a back up to various Lunasix, Minolta or Gossen meters. As John says not very sensitive. A certain retro charm now from a piece of pretty poor British design and engineering; hold the meter vertically and take a reading, now turn it on its side and take a reading - different result by about a stop!.
I had a WM IV, and I may later have had a V (can't remember), and my abiding memory of it was the ease with which the meter glass came loose if you dropped it - I think I had mine repaired for this problem on several occasions. Whatever the make, give me a solid state meter anytime.

Comment by jeallen01 posted on Weston Master V Light Meter at 27/03/2013 - 16:55

jeallen01
JAK wrote:
jeallen01 wrote:
The link was in my first post!
That link is to this forum, albeit a different thread. By other forum I presumed you meant the American one or somewhere!

John K
The link was in the 1st post but in the 2nd para under the highlighted word "here" in "(see the images here)". As you guessed, it is to the American forum!

Comment by jeallen01 posted on Kenko converter 2x at 26/03/2013 - 09:52

jeallen01
JAK wrote:
I suppose that's possible because the contacts were designed to work a power zoon, not auto-focus. My understanding is that autofocus may not work correctly with too small an aperture, with the K-5 being less affected.

I'm not sure to what issues you are referring to on the other forum so cannot comment - do you have a link?

I've got the 1.4x version with the PZ contacts which only looses a single stop instead of two, so is less prone to lacking light to work.

John K
Just tried my Pz-AF Kenko 1.5x with my DA ED 18-135 F3.5-F5.6 Pentax lens with both the K-5 and the K-R in fairly bright bedroom light and it seems to work fine @ 135mm with both of them (and possibly better with the K-R!!). Of course, what it would do with other DA lenses may be another matter.

However, you probably will have more problems with the 2x TC (I do with the Sigma 2X on the longer non SDM Sigma zooms, so do not use it much)

Comment by jeallen01 posted on Kenko converter 2x at 25/03/2013 - 20:51

jeallen01
Thanks for all the above replies - had never actually heard of Red Snapper tripods before, but having had a look at the website, I see you guys mean.

Just looks like a matter of deciding which one to buy - in that context, does anyone have comparative experience of the 3 and 4 section Re 283 and 284 versions? (Apart from the lower retracted and extended heights, my guess is that the 3 section should be slightly more rigid because there are fewer sliding joints involved?)

OTOH, the RS 324 has the flip locks which I guess might be more postive (but it's also a fair bit heavier).

John

PS: Algernon & co, I see what you meant about not needing another head under the gimbal mount - thanks for that too.

Comment by jeallen01 posted on A new tripod? at 25/03/2013 - 20:38

jeallen01
JAK wrote:
I suppose that's possible because the contacts were designed to work a power zoon, not auto-focus. My understanding is that autofocus may not work correctly with too small an aperture, with the K-5 being less affected.

I'm not sure to what issues you are referring to on the other forum so cannot comment - do you have a link?

John K
The link was in my first post!

Comment by jeallen01 posted on Kenko converter 2x at 25/03/2013 - 08:23

jeallen01
JAK wrote:
If I may comment, the one at http://funchal.olx.pt/kenko-teleconversor-fotografico-2x-pentax-iid-433649958 looks like it DOES have the PZ contacts so would autofocus with DA* lenses. You can see them at about the 5 o'clock position on the interior black surround, that is providing the picture is of the actual item and not a stock image in which case who knows! Maybe worth double checking it is the actual thing before purchasing it.

John K
OTOH, the reviews on the other forum indicated some issues with some DA lenses.

Comment by jeallen01 posted on Kenko converter 2x at 24/03/2013 - 21:22

Proudly supporting Pentax User

Samsung Logo Asahi Pentax Logo