All Forum Comments
Comment by Frogherder posted on K10D battery problem at 06/03/2012 - 20:20
Bernard
Comment by Frogherder posted on Another pointless thread at 05/03/2012 - 23:38
Not noticed any other quirks "yet"
Bernard
Comment by Frogherder posted on New Firmware at 05/03/2012 - 23:33
You "might" glean some info from :-
http://www.pentaxforums.com/forums/pentax-k-5-forum/177445-new-firmware-1-13-a.h...
The again you might be just as confused
regards
Bernard
Comment by Frogherder posted on New Firmware at 05/03/2012 - 13:00
So, I assume at that point you've reached the stage that you can't do it your self, then this has to be done by a repair shop
So I think my point stands, all is not lost. At worst its a repair job, at best the camera will function "better?" once you've finished and the cost was zero
regards
Bernard
Comment by Frogherder posted on New Firmware at 05/03/2012 - 12:18
We went on to the Viking Ship museum
If it is, is it still as cold inside? .
Went there some years back - minus 20 outside, apparently plus 4 inside but it felt much much colder inside than out brrrrrrh
Bernard
Comment by Frogherder posted on Another pointless thread at 05/03/2012 - 11:58
Tempted to try a household vacum cleaner, from a long distance...
I tried this method to clean the dust and crumbs? out of my keyboard and managed to suck up one of the keys. Not quite a disaster in the same league as sucking up the sensor as I simply superglued it back on after grubbing through the cleaner bag
regards
Benrard
Comment by Frogherder posted on KR Stain at 05/03/2012 - 11:53
What happens if a failure happens?, assuming that you've followed the instructions to the letter.
What happens if, for example, a battery fails during the update?
Is it simply a matter of sending the camera to someone like Johnsons, in which case it's an expensive failure or is the camera effectively scrap?
regards
Bernard
Comment by Frogherder posted on New Firmware at 05/03/2012 - 11:48
Bernard
Comment by Frogherder posted on Another pointless thread at 04/03/2012 - 17:25
Only query I have is :-
Caution
•Only K-5 users are permitted to download the firmware update.
Bernard
Comment by Frogherder posted on New Firmware at 04/03/2012 - 15:57


When fully charged the stack will often show full value, but the terminal voltage drops off very quickly.
This has been a problem with Zinc Carbon; NiCd; NiMH so I doubt if Li battery packs are immune.
Next time your door bell fails and need a new 12v battery carefully open the metal case and take out the tiny cells, you will almost certainly find that 1 or maybe 2 are completely flat and the others are still reasonable. Replace them with a couple of similar cells from say Poundland and you're up and running again for ages.
Bernard