Dust alert problem

Greetings,

I recently used the dust alert to see if i had missed any after removing a speck. All was well but a little later when I wanted to take a picture I got a message saying the image could not be saved! And then, there was a bug when trying to review the pictures. The red light would light indicating access to the card and then nothing, it would just stay on. Not even turning off the K-x would close the red light! I reluctantly removed the card and placed it in the card reader of my computer. Everything was ok. I saved all the pictures replaced the card in my K-x and formated the card. Everything is good since.

What happened?

Could be a software glitch.

That sounds possible, latest firmware here for the K-x.

Hope this helps.

Do you format your cards regularly? if not perhaps that might explain the glitch? (Just clutching at straws here!)

Regards - Pete.

Thanks everyone. it seems the card has something to do with it because when I switched for another card everything went well. Three attempts with the original card ended up in failure.

Best regards

It's worth trying to clear the card on a PC and then try formatting it in the K-x again if you haven't already tried that.