Gahame_05

Joined: 11th February 2009

All Forum Comments

Topics Created Topics Contributed Forum Comments Photo Comments

All Forum Comments

Gahame_05
I made my Vivitar Macro Focussing teleconverter work in conjunction with A series lenses and took out the Ricoh pi and it WAS NOT EASY

On removing the four screws all the pins dropped out each one on its 4mm little spring. These sit in between the top which had been removed and a conducting tab - one for each of the 6 pins and another for the seventh (Ricoh) pin

In addition I found out why the adaptor wouldn't allow my K20D to show the aperture when an A series lens is attached in Auto mode.

This was because each of the pins has an associated longer spring attached to the other end of the converter. Thank goodness these other ends hadn't come off

I carefully hooked the springs back onto the little tabs - which annoyingly also come off.

Then you have to put all six pins into the top of the mount and turn the teleconverter upside down or else these pins, their springs and sometimes the little tabs all fall out again

You have to be careful that all of the pins appears from the top side of the lens

As if that wasn't enough, I had to do this whole procedure about seven times because it also appears that the location of the two swivelling connectors has to be just right other wise one of them can't move througout is entire travel and when you put the screws back in, the lens won't attach to the converter

I nearly gave up altogether. IT TOOK ME OVER 3 HOURS IWTH A LARGE MAGNIFYING GLASS, SCREWDRIVER AND TWEEZERS

Eventually by moving the levers at the same time as assembling it upsde down I managed to get it to a state where the elevers had full travel and the pins were all located. This was still with the assembly upside down but with my holidng it together with my fingers

Finally I turned the unit the right way up and put the four screws back

I never want to do this again.

On the plus side, I can confirm that the only way to have the unit working so you can fully use a Pentax A series lens is if all those six springs are attached each to its own tab. I overstretched one of the six springs but managed to hook it on further down and cut the excess off with a pair of side cutters. I made sure that no electrical contact was possible with this somewhat mangled spring and its neighbour

Maybe taking the pin out of a lens is easy but the macrofocussing teleconverter is a complete nightmare

Best

Grahame

Comment by Gahame_05 posted on Vivitar 2x macro focusing teleconverter: Auto aperture at 21/11/2012 - 11:07

Proudly supporting Pentax User

Samsung Logo Asahi Pentax Logo