Sensor Spots

Ok, not so much of a trouble shooter really but my questions are:

a) should I have a go at cleaning my Kr and K200d sensors myself; and

b) if so, what tips recommendations do other forum members have?

Thanks, Andrew

here you go my friend is not that bad to do

link

Yes clean them yourself.
Don't use a blower - you can blow crud into the body. Someone even managed to damage their sensor with one I believe.

I use an Arctic Butterfly to clean mine. They cost a lot but are a good investment imho.

Alternatively buy something like these and go the wet route.

Make sure the battery is fully charged before you start - you do not want to run out of battery half way through!

I finally bit the bullet and did mine, and I was quite pleased at how simple it was. I bought a set of ten cleaning pads and liquid off Amazon for about a tenner, followed the supplied instructions, and it was fine.

I never got the camera to lift the mirror when using standard batteries, I had to switch to Eneloops and update the firmware, once I'd done that it was fine. (K-x)