Entering a photo competition
Posted 10/08/2007 - 22:34
Link
I like to have some sort of surround for my photos. I feel it helps to focus attention on the pictures themselves, as you can see on my entries for our "in house" competitions.
Posted 10/08/2007 - 23:27
Link
I'd print at least A3 (equivalent) so it can be viewed from a distance.
Posted 10/08/2007 - 23:44
Link
Our standard for competition entries is a 20" x 16" board and any size of print over 6" x 8". Sue and I print to A3, which gives a reasonable border.
This spec is used by ADAPS and all clubs in the L&CPU (Lancashire & Cheshire Photographic Union)
It might be a good idea to go this big as it will look very impressive.
This spec is used by ADAPS and all clubs in the L&CPU (Lancashire & Cheshire Photographic Union)
It might be a good idea to go this big as it will look very impressive.
Best regards, John
Posted 11/08/2007 - 00:02
Link
I generally print out at A4 (thats as far as my printer will go) however I do note that a very large number of prints obviously printed on A3 printers do rather well in my camera clubs various competitions, but at the end of the day it all comes down to the print, its a waste of time printing at A3 if you've cropped and reduced the quality of the image, or if printing at such a size reveals large areas of noise etc
Mounting; if you intend to mount a lot of your own prints then invest in a simple mount cutter and buy the mounting board uncut, alternatively buy a ready cut mount, but this will restrict your image size.
EDIT......PS as John said, 16x20 is a good size for a mount , although IMHO anything much less than an A4 print would be lost on such sized board
Mounting; if you intend to mount a lot of your own prints then invest in a simple mount cutter and buy the mounting board uncut, alternatively buy a ready cut mount, but this will restrict your image size.
EDIT......PS as John said, 16x20 is a good size for a mount , although IMHO anything much less than an A4 print would be lost on such sized board
Posted 12/08/2007 - 10:06
Link
It's the same in the East Anglian Federation; maximum 20x16" mount-if you enter their annual exhibition they MUST be all on 20x16" mounts and they are MEASURED would you believe it ? My wife and I entered the EAF Exhibition through our club Brentwood Photographic Club and didn't get any accepted as the mounts were fractionally too small ! ( VERY PETTY!)
Been a member of Pentax Club since the Ron Spillman era! Got COMPUTERISED at last - DIGITISED?
Taken the PLUNGE - BUT FILM STILL RULES !!!
Taken the PLUNGE - BUT FILM STILL RULES !!!
Posted 12/08/2007 - 10:47
Link
Yes, we had a similar problem up here. Some prints were rejected because they were 2mm out on the mount measurement.
A virtual revolution from more than 7 clubs had the matter revisited very quickly and sanity was restored.
A virtual revolution from more than 7 clubs had the matter revisited very quickly and sanity was restored.
Best regards, John
Add Comment
To leave a comment - Log in to Pentax User or create a new account.


33 posts
19 years
Leicester
The advise I am seeking is this - the prints have to be mounted. Should I go for a borderless mount or an edged mount? The rules state the entries have to be mounted but no frames allowed.
Can be any size as long as it's more than 7 x 5. What sort of size should I go for? Any comp advise appreciated.